Quote:
Originally Posted by derbo
Quote:
Originally Posted by LandoT
All I saw was RPA which I set to enable in DSC, I will have to comb through the options again to double check it was the only one.
|
What version of DSC module do you have? MK60_87.Cxx? This is a non-M right?
In MK60_87.C0F, there is a parameter called C0F_RPA - wert_00 = !direct_RDC |
All I have seen in the DSC menus on Protool is "variante: DXC_90_16" it's a 2011 E91 328 xDrive.
The RPA options I found:
Ausstattung_RPA, which I have disable for now but it was enabled when I was getting the FTM error.
RPA_Warnschwellwert_1 set to value 2
RPA_Warnschwellwert_2 set to value 1
RPA_Warnschwellwert_3 set to value 04
RPA_Warnschwellwert_4 set to value 09
There is also US_Variante: enabled in the expert mode of Protool under the Tire puncture warning (RPA) threshold value menu.
The only other RPA setting I've found was in JBBF which is RPA_Switch. I set that to active but I am still getting the error with a greyed out Reset button in the CIC