Performance Wheel V2 Wiring to CAS

Salut tout le monde,

Je viens de m'attaquer à l'installation du Performance Wheel V2 et je viens juste de tout remettre en place, mais le volant ne s'allume pas! (Oui, j'ai essayé d'allumer avec les deux boutons latéraux).

Je suis un peu confus parce que le manuel dit de se connecter au câblage CAS à la broche 1 (brun) et à la broche 12 (brun / noir) (30G), mais sur mon harnais CAS, la broche 1 est en fait rouge. Devrais-je taper le fil brun épais à la place?

Ou bien devrais-je rediriger le câblage vers le harnais JBE de l'autre côté?

J'ai également utilisé des robinets Pico au lieu des robinets OEM parce que c'est un volant d'occasion, donc j'espère que cela ne l'a pas affecté non plus.

J'aimerais que cette chose fonctionne

Merci à tous.

Le même problème, sauf que le mien n'a pas été utilisé.

En outre, j'ai des lumières DSC et ABS sur

I installed a brand new V2 steering wheel on my buddies M3 using this DIY and I had 0 issues: http://www.m3post.com/forums/showthread.php?t=242963

Any solution to this issue, I have the same issue as the OP

Nevermind, I resolved this issue, I ended up wiring the wheel to the CAS, connecting the wires to pin 1 (red) and pin 12 (brown/black stripe) and it works fine.

Did the M Performance Electronic V2 Steering wheel install today and my CAS module PIN 1 wire was also red, just like mentioned in this thread. Pin 12 was brown/black.

speedster77 wrote

Did the M Performance Electronic V2 Steering wheel install today and my CAS module PIN 1 wire was also red, just like mentioned in this thread. Pin 12 was brown/black.

Did you have issues or everything came out ok? I'm about to install this myself

Vedubin01 wrote

speedster77 wrote

Did the M Performance Electronic V2 Steering wheel install today and my CAS module PIN 1 wire was also red, just like mentioned in this thread. Pin 12 was brown/black.

Did you have issues or everything came out ok? I'm about to install this myself

No issues once I labeled everything and followed the diy

speedster77 wrote

Vedubin01 wrote

speedster77 wrote

Did the M Performance Electronic V2 Steering wheel install today and my CAS module PIN 1 wire was also red, just like mentioned in this thread. Pin 12 was brown/black.

Did you have issues or everything came out ok? I'm about to install this myself

No issues once I labeled everything and followed the diy

Same, all is well here too! Loving the wheel!