Track Chat Thread

LateBraking a écrit

Je regardais autour de 2.5k, qui comprend les pneus.... depuis que j'ai vu que les ensembles vont pour 2k pour les roues seulement. :

2500 c'est juste, mais ce n'est pas un bon prix :P

LateBraking a écrit

- 1 carrossage n'est pas recommandé. C'est juste le max que vous pouvez aller avec les broches. Retirez les broches et obtenez -1.6, maintenant c'est recommandé, surtout depuis que vous suivez. Vous allez probablement porter le centre et à l'extérieur du pneu et tuer les pneus prématurément compte tenu de votre utilisation des pneus.

L'alignement est confus

persian54 a écrit

2500 c'est juste, mais ce n'est pas un bon prix :P

C'est pour ça que je ne vends pas à des mecs.

persian54 a écrit

L'alignement est confus

Ne le touchez pas. Si vous obtenez des pneus différents, vous effacerez sans frotter et vous n'aurez aucun problème. L'usure des pneus sera-t-elle un problème avant le retour du bail? Je ne sais pas combien de temps ça va durer, d'où la question.

persian54 a écrit

2500 c'est juste, mais ce n'est pas un bon prix :P

Oui, vraiment.

LateBraking a écrit

C'est pour ça que je ne vends pas à des mecs.

Drats !

LateBraking a écrit

Ne le touchez pas. Si vous obtenez des pneus différents, vous effacerez sans frotter et vous n'aurez aucun problème. L'usure des pneus sera-t-elle un problème avant le retour du bail? Je ne sais pas combien de temps ça va durer, d'où la question.

J'ai entendu des résultats mitigés à propos de 265/30/19 AD08s déblayant l'avant, et EAS m'a dit que 295/30/19 frottera 100% à l'arrière sans un peu de cambrure négative.
Ils ont -1.5 F -.5 R, mais leur jante est 19x10 et 25, où la mienne est 10x10.5 et 22... alors ouais

persian54 a écrit

J'ai entendu des résultats mitigés à propos de 265/30/19 AD08s déblayant l'avant, et EAS m'a dit que 295/30/19 frottera 100% à l'arrière sans un peu de cambrure négative.
Ils ont -1.5 F -.5 R, mais leur jante est 19x10 et 25, où la mienne est 10x10.5 et 22... alors ouais

19x10 et25 versus 19x10,5 et22 devraient être très similaires en termes de clairance. La différence entre les deux configurations est d'environ 3 millimètres. en clair.

Regardez comme une différence de 3 millimètres est petite... :

http://iruler.net/

Mais oui, s'ils disent qu'un 295 va frotter, alors allez-y pour un 285. J'utilise un 285 en ce moment, pas de frottement, mais AD08 est plus carré que la PS2, donc si vous voulez être en sécurité, optez pour un 255 avant 275 arrière AD08 et je m'aventurerais à deviner que ce serait beaucoup plus sûr.

LateBraking wrote

19x10 et25 versus 19x10.5 et22 should be really similar in clearance. The difference between the two setups is around 3 millimeters. in clearance.

Check out how small a difference 3 millimeters is.... :\

http://iruler.net/

But yeah, if they say a 295 will rub, then just go for a 285. I'm using a 285 right now, no rubbing, but AD08 is more square than PS2, so if you want to be safe just go for a 255 front 275 rear AD08's and I'd venture to guess that that would be plenty safe.

3mm in offset, but the rear is also .5in wider


the thing is, their car is lowered..I'm stock height

they don't make a 285/30/19 AD08...otherwise I wouldn't be having any issues right now :/

255/35/19 F AD08s rub 100% because the tire is .6 inches taller than a 260/30/19. I researched this quite a bit lol

a forum member has 19x9.5 et 22 265/30/19 AD08s in the front (stock e90 ZCP) and he has no rubbing whatsoever.
ZCP is lower than non-zcp. so in affect I should be okay
Martin D said the front rubs, but he was really low

my only issue is the 295/30 rear
I noticed everyone who rubs is lowered...I'm stock height, but the rear does sit low with the top open.... so as long as I don't drive top down on the 10 freeway with 4 people I should be fine..

Best part for me is that James is going to run 295/30/19 rear, so he said I can test fit :P

If it clears, I'm ordering a set asap

i just wish they made a 285/30/19 AD08!

this site lists 285/30/19 AD08s..
http://www.d3wheels.com/tires/285-30-19.html

but Tirerack doesn't...
http://www.tirerack.com/tires/tires.jsp?tireMake=Yokohama&tireModel=ADVAN+Neova+AD08

persian54 wrote

3mm in offset, but the rear is also .5in wider


the thing is, their car is lowered..I'm stock height

they don't make a 285/30/19 AD08...otherwise I wouldn't be having any issues right now :/

255/35/19 F AD08s rub 100% because the tire is .6 inches taller than a 260/30/19. I researched this quite a bit lol

a forum member has 19x9.5 et 22 265/30/19 AD08s in the front (stock e90 ZCP) and he has no rubbing whatsoever.
ZCP is lower than non-zcp. so in affect I should be okay
Martin D said the front rubs, but he was really low

my only issue is the 295/30 rear
I noticed everyone who rubs is lowered...I'm stock height, but the rear does sit low with the top open.... so as long as I don't drive top down on the 10 freeway with 4 people I should be fine..

Best part for me is that James is going to run 295/30/19 rear, so he said I can test fit :P

If it clears, I'm ordering a set asap

i just wish they made a 285/30/19 AD08!

No, I meant, 3 mm difference total. It's 3mm less offset followed by 6.35mm greater width (0.25 inches). 6.35-3=3.35mm, so I said about 3mm because I was just being lazier. This is a really dumbed down calculation and it's open to a lot of error though, but it should be around 3mm....

LateBraking wrote

No, I meant, 3 mm difference total. It's 3mm less offset followed by 6.35mm greater width (0.25 inches). 6.35-3=3.35mm, so I said about 3mm because I was just being lazier. This is a really dumbed down calculation and it's open to a lot of error though, but it should be around 3mm....

do you know how to remove the pins?
you can text me :P

persian54 wrote

do you know how to remove the pins?
you can text me :P

Easier for me to post you the link to the DIY than text you.

http://www.m3post.com/forums/showthread.php?t=521177

LateBraking wrote

Easier for me to post you the link to the DIY than text you.

http://www.m3post.com/forums/showthread.php?t=521177

complicated...

persian54 wrote

complicated...

Just leave it stock. lol It's just a whole lot less complicated that way.

My rotors are shot.

Hairline cracks all around the drilled ports and warped. Tried getting the pad deposits out, but they are simply warped.

The joys of the track.

Malekreza11 wrote

My rotors are shot.

Hairline cracks all around the drilled ports and warped. Tried getting the pad deposits out, but they are simply warped.

The joys of the track.

Damn

will dealer replace them? just switch rims for now!

you can borrow mine if you want

Malekreza11 wrote

My rotors are shot.

Hairline cracks all around the drilled ports and warped. Tried getting the pad deposits out, but they are simply warped.

The joys of the track.

http://forums.racingbrake.com/showthread.php?t=777

Reply to the thread showing interested so RacingBrake comes out with some 2pc rotors for us

Malekreza11 wrote

My rotors are shot.

Hairline cracks all around the drilled ports and warped. Tried getting the pad deposits out, but they are simply warped.

The joys of the track.

persian54 wrote

Damn

will dealer replace them? just switch rims for now!

you can borrow mine if you want

If he knows someone that works at a dealer, I'm sure they'll help him out. Rotors are regularly covered under the service plan anyways. They don't like to replace rotors that have been tracked on, but I haven't heard of too many situations where it's been refused.

Switching rims won't help him, his wheels are fine I suspect.

Good luck Malek!

Late Braking said he was gonna give me his rims and tires as a gift. juss sayin.

m3heaven wrote

http://forums.racingbrake.com/showthread.php?t=777

Reply to the thread showing interested so RacingBrake comes out with some 2pc rotors for us

Tell them to register a name here, I don't think they need to be a paying sponsor to just ask questions, just to sell products, right? They'd get better results making a poll in this forum.

I already have Brembo BBK, but if I didn't, I would have been interested in something like this.

E90///M3` wrote

Late Braking said he was gonna give me his rims and tires as a gift. juss sayin.

I thought you were sober in Vegas, guess you were drunker than I thought, you were hearing things.

LateBraking wrote

I thought you were sober in Vegas, guess you were drunker than I thought, you were hearing things.

i swear i was a few drinks in by the time you got there that night.

E90///M3` wrote

i swear i was a few drinks in by the time you got there that night.

No wonder you thought I said something loony like free wheels and tires. Only shift knob for you!

It's ok, you weren't the craziest one that night. Between Puldog....and Roma hitting on a girl that just got married....

Have fun at Oakley, let me know how it goes. I'll show up if I can.