Problem when I get accelerated

I have a BMW E92 M3 2008
Before a month ago I was in a vaction and my car was in my garage
When I arrived. I go to my car and put the key and start engine.
Everything was ok!

But, when I over 4500RPM I get a LIMP MODE.
When I turned car off. And start again-nothing.

But again, over 4500 rpm-problem.

The code is in bank 2

I thought is the actuator so i replaced the gear both of 1 and 2 and also replaced the hall sensor. Replace them-and nothing
The same problem.

There is maybe a TBA? TPS Resset?
I do not have a insta or INPA

The car goes great, but with a strong squeeze on the throttle, the malfunction turns on.
I would be happy to solve this problem

Thanks
MATAN

Could be a few different things. I've noticed when my car sits for more than a week, sometimes it will run kinda crappy in the beginning. I have a new battery so maybe it's just a low charge or it just doesn't like to sit.

Your issue could be bad gas or something battery related. Maybe drive it awhile, get it nice and warm with fresh gas and see how it responds. The limp mode only on full throttle is weird to me, never had limp mode in my situations

anyone ?

Replacing just the gears to your actuators is never a guarantee fix.. it could be that your Mosfets are also burnt out..
I would recommend completely new (or expert refurbished) actuators for both banks..

ok
replaced 2 actuator bank 2 and 1
and still got a 2b26 code... (bank 2)

update : i can over the 4500 rpm and also 5000.
only when i Press the pedal in full at once
i get a limp mode

Can you get the Carly app and an OBDII wifi dongle? If so, you can reset the fault codes yourself and see if they come back.

Take a look at https://www.m3post.com/forums/showpost.php?p=15368740&postcount=44