Rod bearings went on a '11 S65 engine.
Need a new one
Need a new one
BIMMERPOST Classifieds
WTB: S65 Engine
SOLD
Listed by
diargon
Trade History
No Ratings Yet
Safety Disclaimer: BIMMERPOST does not verify the authenticity of listings, buyers or sellers. You are dealing with third-party individuals. Always conduct due diligence, use secure payment methods that offer built-in buyer and seller protection, and protect yourself against fraud. Never use non-reversible payment methods (like direct bank wire or peer-to-peer cash apps) with strangers
Trader Profile
Loading...Recent Transactions
Loading history...
2.1KVIEWS
6REPLIES
0APPRECIATES
08-06-2020LAST POST
ooppsss What was your milage?
What was your milage?
TrAcK TRaP wrote64000 😔 only had the car for a year. Put 4K mi on it and this happens. Very bad luck.ooppsss
My last car was an N55 that also had rod bearings go.
Both cars babied, but bought used. Guess I find the worst ones 😬
Feel bad for you.
But, hey, it's not your fault, if you didn't know about it. Now you know that you need more clearance on the RBs. Have it when you get your new engine.
But, hey, it's not your fault, if you didn't know about it. Now you know that you need more clearance on the RBs. Have it when you get your new engine.
could this be a 2011 stuck injector problem?
Check out this post: https://www.m3post.com/forums/showthread.php?t=1326457
TX wroteIt could be, but they seem very rare so far, if you look on the sorted list I posted the RB registry thread you'll see that only a few suffered from stuck injectors.could this be a 2011 stuck injector problem?
Thread referenced by Assimilator1 in Blown motors, S65 failure registry - v2, failures catorgorised 03-29-2024
