Reverse Logic Jack Pad Tool Promotional Offers

The bundle offer with our R50JPT for BMW chassis and our 6061 lug bolt guide tools is just about over. We only have the M14x1.25 6061 aluminum wheel hangers left.

We recently introduced a new series of 2024 aluminum lug bolt guide tools with a non-abrasive knurl. Our latest bundle offer combines one of the new lug bolt guide tools with our latest Multi-vehicle MV52-30-19 jack pad tool.

The aluminum block on the MV52-30-19 jack pad tool measures 52mm long by 30mm wide by 19mm high. These dimensions allow this tool to be used with cars that have an integrated vehicle jack pocket in the factory jack points. This includes all modern BMWs, MINIs, some non-AMG Mercedes, and the Nissan GT-R. A low profile floor jack is normally required to use this tool.

This jack pad tool is intended to be used with a floor jack with a flat bottomed saddle that is at least 3-inches in diameter. The lug bolt guide tool is available in three thread sizes, M12x1.5, M14x1.5, and M14x1.25. Both the jack pad tool and lug bolt guide tools are made in the USA.

http://www.reverselogic.us/shop.html#!/~/product/category=5710065&id=34804794

Make it easy for me, what should I order for an e93 M3? Looking for guide and pad.

Click here:

http://www.reverselogic.us/shop.html#!/~/product/category=5710065&id=34804794

The M12x1.5 lug bolt guide tool needed for the E93 is the default selection.

Genericuser1 wrote

Make it easy for me, what should I order for an e93 M3? Looking for guide and pad.

thanks!

Just swapped my winter to summer setup and these bits worked great. The lug bolt guide was a huge time saver.

All my previous cars have had lugs bolts to hang the wheel on so it would have been a royal pain without it the guide.